
Instruction Manual
4
2. (Only required if the drive installation screw and stando requires relocating)
Remove the nut holding the SSD stando in place on the reverse side using a small
5mm wrench/nut driver, or needle nosed players (not included).
3. (Only required if the drive installation screw and stando requires relocating)
Remove the SSD installation stando, and reseat it into the drive installation hole
that matches your SSD. Replace the nut on the reverse side and secure it into place
using a 5mm wrech/nut driver or small set of needle nosed plyers.
Comentarios a estos manuales