Startechcom CONYX ECS0016 Manual de usuario descargar pdf (Pagina 122)

Instruction Manual

115

To set the Username ﬁeld (SNMP version 3 only):

congsetcong.system.snmp.username2=yourusername..

(replacing yourusername with the username conﬁg.system.snmp.

username2 (3 only))

To set the Engine ID ﬁeld (SNMP version 3 only):

congsetcong.system.snmp.password2=yourpassword ..

(replacing yourpassword with the password)

Once the ﬁelds are set, apply the conﬁguration with the following com-

mand:

congrunsnmp

You can add a third or more SNMP servers by incrementing the “2” in

the above commands, e.g. conﬁg.system.snmp.protocol3, conﬁg.system.

snmp.address3, etc.

nﬁg instead of /etc/ssh_conﬁg •

/etc/conﬁg/users/<username>/.ssh/ instead of /

home/<username>/.ssh/

Power Strip Control

The console server supports a growing list of remote power-control

devices (RPCs) which can be conﬁgured using the Management Console

as described in Chapter 8. These RPCs are controlled using the open

source PowerMan tools and with the pmpower utility.

PowerMan

PowerMan provides power management in a data center or compute

cluster environment. It performs operations such as power on, power

off, and power cycle via remote power controller (RPC) devices. Target

hostnames are mapped to plugs on RPC devices in powerman.conf

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 139 140

Sin comentarios

Startechcom CONYX ECS0016 Manual de usuario Pagina 122